Aircommand Sparrow Mk4 Installationsanleitung PDF herunterladen (Seite 8)

Sparrow Mk4 Installation Guide 20

Dec 2012 Page 8 of 14

4. POSITION SPARROW ON ROOF

- Remove the air conditioner from the

carton and move to installation position

- Put a circle of sealant around each bolt

hole in the weather collar

- Position the unit over the weather

collar. The unit will engage with the collar

and self-align (Fig 6).

The unit weights approximately

28kg. Ensure a two person lift or

use a mechanical hoist to avoid

the risk of injury.

- DO NOT slide the unit on the roof, this

may damage the weather collar and

result in leaks

- Four M8 mounting holes on the chassis

underneath the air conditioner will line

up with the corresponding holes on the

weather collar

Fig 6: Apply sealant around bolt holes and then position unit over the weather collar and set

down gently.

5. CONNECT ELECTRICAL SUPPLY

- This unit MUST be installed in

accordance with State and National

Wiring regulations and in particular

AS3001 – 2008

- Refer Fig 7 for position of terminal block

- Connect electrical supply to terminal

strip. Note position of active, neutral and

ground wires (Fig 8)

WARNING

This work should only be performed by a

licenced electrical tradesperson.

Ensure that power is properly

disconnected at the supply (mains

and/or battery

- When connecting wires into terminal

strip apply suitable clamping pressure to

ensure wire is secure while taking care

not to over tighten and damage the

exposed wire ends.

Fig 7: Highlights the position of the terminal strip underneath the unit

Fig 8: Wiring diagram of power connection from external supply to air conditioner

Apply circle of sealant

around 4 bolt holes

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Aircommand Sparrow Mk4 Installationsanleitung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Split-System-Klimaanlagen Aircommand Sparrow Mk4